Thank You for these instructions- they were well written -everything I
disassembled followed step by step. You do need a E5 inverterd torx bit for
the ignition screw bolts - most standard sets only go to E6- you may need to
pick this tool up for your local tool supplier (Snap-on. Mac or Matco.)
I had a 2001 G/P - the ignition key would not come out with out hitting the release and the shifter would not move without hitting the release- I had no
power at the BTSI fuse that feeds power to the shifter lock release. The BTSI fuse gets it power from the white wire that comes form the ignition switch.