View Single Post
Old 12-17-2009, 10:42 PM   #13
Panoz26
AF Enthusiast
 
Panoz26's Avatar
 
Join Date: May 2008
Location: Raleigh, North Carolina
Posts: 580
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Rear end re-seal

Quote:
Originally Posted by David Eastman View Post
Jim,
Glad I could help.

Brian,

To answer your question it is yes and no. This is a standard 9 in. diff housing and chunk but the axles and hubs are not standard. The axles are floating. There is a tube inside the axle tube were the seal is installed. Oil should not be in this tube inner tube. If oil is is in the tube than the seal is leaking. Having said that these seals do not work very well so if you have a small amount of oil in the tube its ok. The reason you do not want oil in the tube is because the wheel bearings run in grease like the front wheel bearings. If the hot oil gets to the outer wheel bearings the oil will melt the grease and you will have bearing failure. The only seal on the outer hub is a paper gasket. So if you have oil leaking out of your hubs it is a mixture of diff oil and melted grease. Not good.

David
_____________________
resurrecting an old post:

OK, I have a small amount of "fluid" coming from my rear passenger hub - after reading above, it seems as if I need to replace the seals on the hub(s) as well as the Diff seals - is this correct?

thanks
Devin.
__________________
Devin - (aka Panoz26)
Formally WC Car # 26, Red
Now = WC-GT2 # 211, Black

Panoz26 is offline   Reply With Quote