Quote:
Originally Posted by PeteA216
Cool, thanks! Gaskets for this ol'd thing are hard to find, and expensive because of their rarety, so I'll take everything apart, reusing old gaskets if possible, and use a bunch of gasket sealer. I hope it helps. Thanks again!
|
I wouldnt re use old gaskets, but try to find some Gasket Paper. You just trace the surface that needs a gasket onto the paper, then use contact cement and hold it to the piece while you use a xacto knife to cut out any holes or bolt holes.
Bolt holes are hard, I use a hole punch, like a little hand one to make bolt holes. It makes clean holes and is easy
you might have to trace were bolt holes are first before you contact cement it on, cause once its cemented on you cant take it off.