View Single Post
Old 03-09-2010, 09:54 PM   #13
drm2670
AF Newbie
 
Join Date: Mar 2010
Location: Chicago, Illinois
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Chrysler 300C Hemi transmission problems

I had a pretty scary moment w/ the car yesterday. I drove onto the freeway (4 lane's each way) in Chicago. When I was going down the ramp, I started to merge. I had to punch the throttle to get ahead of a car. Right when I punched the throttle, the transmission started to slip. After about 2 seconds, the car wasn't moving. It was in drive, but I was revving the engine like it was in neutral. Then, I hear a ding. I looked down on my dashboard and saw the engine light turn on. I was pretty much a sitting duck, because I was in the middle lane, and cars were zipping past me on both sides, and there was basically no curb on the freeway- just cement walls. My car was just coasting, so I put it into neutral, and then a few seconds later, I put it into drive. I hit the accelorator, and the transmission was still slipping, but then finally caught and I was able to drive. I thought I was going to get into an accident for sure, because I had no power in the center lane in busy (fast) traffic on the freeway in Chicago, and there was no curb to go to.

I took it to the dealer (pretty pissed off since they just looked at the transmission last week). They looked at it again, and saw that the gear shift ratio was off, and then they found a leak in the transmission. They said that the transmission fluid was basically empty (seems like they should have caught that last week). Anyways, at least they caught the problem and fixed it. However, I'm a little scared to drive it, because I lost power at the worst possible time. the car has only 9,000 miles on it. I'm thinking of getting rid of it for sure. Sorry Chrysler fans, but it's to dangerous for me to drive, especially since I have a daughter.
drm2670 is offline   Reply With Quote