View Single Post
Old 04-08-2001, 06:21 PM   #1
Old Mod
enzo@af's Avatar
Join Date: Nov 2000
Posts: 1,506
Thanks: 0
Thanked 2 Times in 2 Posts
Send a message via ICQ to enzo@af Send a message via AIM to enzo@af
I just bought some Intrax springs, and I was wondering if a friend and I should try and install them ourselves, or should I just pay the dough and have them professionally installed.

So, does anyone here have experience doing this? I can get them compressed for pretty cheap, it would just be a matter of swapping them for the stock springs. However, I worry about correct camber, and everything else that could go wrong.

If anybody has any suggestions on the matter, please either reply or give me an e-mail or get ahold of me on ICQ!!!!

Thanks, and later.
I've said it before, I'll say it again. "Nobody does rip and snort like Ferrari"
enzo@af is offline   Reply With Quote