[Tony]

Pictures

I don't feel like editing the original posts and adding these pics to each one, so I will just add them all here.

Main Harness Plug

Spoiler for Picture:

Notice the small plastic tabs under each pin. This is what you will want to press back to remove the pin.

MPFI Injector Plug

Spoiler for Picture:

TPS Plug

Spoiler for Picture:

Swap the Green and Yellow wires.

TPS Plug #2

Spoiler for Picture:

Another look into the TPS Plug.

IACV Plug

Spoiler for Picture:

This is your IACV Plug. It is Honda's standard 2 wire plug and can be plugged into many things, but it should only go to the IACV.

Injector Resistor Box Plug

Spoiler for Picture:

Injector Resistor Box Plug #2

Spoiler for Picture:

DPFI Seconday Injector Plug

Spoiler for Picture:

Primary plug looks just like it, but its Brown.

MPFI Distributor Plug

Spoiler for Picture:

Back side of the plug, notice the White wire by itself on the bottom.

MPFI Distributor Plug #2

Spoiler for Picture:

Other side of the plug, the White wire I mentioned earlier is on the left side here.

DPFI Distributor Plug

Spoiler for Picture:

DPFI Distributor Plug #2

Spoiler for Picture:

The lonely White wire is on the Left side here as well...its a little dirty.

DPFI Distributor Code

Spoiler for Picture:

Just to show where the Distributor code is at so you can make sure you have the correct one.

DPFI Distributor Code #2

Spoiler for Picture:

Further back shot of the code, just to give a better location of it.

PM6 ECU

Spoiler for Picture:

The middle set of numbers/letters is what you are looking for on ECUs.