I figured it out. You have to pull of the A/C knobs with pliers and unscrew the screws behind the knobs. Then you have to take a screw driver or something like that and pry it along the outside of the panel around the radio. Wrap it with tape so that it wont scratch the panel. Slowly work your way around the panel so that you can loosen all the clamps holding on. When you get to the last few, it should pop right off and you can then unscrew the radio and take it out. When you install the new radio, either buy a wireing harness or hardwire it straigh in. But hardwireing it, as i found out might void the warranty of the radio if you have one or w/e.