View Single Post
Old 06-27-2005, 08:26 PM   #8
Brian R.
Resident Chemist
Thread starter
 
Brian R.'s Avatar
 
Join Date: Feb 2004
Location: Rockville, Maryland
Posts: 8,586
Thanks: 105
Thanked 157 Times in 157 Posts
Send a message via Yahoo to Brian R.
Re: Camry FAQs and Information

Thanks to sanengo and Toysrme for the following ideas:

Want more horsepower? Not enough money for a Turbo/SC?

Q: How do I increase the power of my Tacoma?

A: Performance headers (Not emissions safe)

Installing a performance air filter or cold air intake (CAI) is not a very wise investment for power, but if every bit helps, and you enjoy a more throaty sound, go for it. Get recommendations from others with your engine. Some intakes actually cost you power, but sound louder.

[Brian edit]Make sure there is some give to the CAI system. Some CAIs bolt directly to the engine and to the body at each end. When the engine moves, the end bolted to the body has no give and may tear the bolts out of the body where attached.

TRD, AEM, and AMSOIL sell excellent and reusable oil-impregnated air filters. The AEM and TRD filters are the same and are cotton-fiber based. The AMSOIL filter is multi-layer foam.[/edit]

CLEAN YOUR ENGINE TO REGAIN LOST POWER! Carb cleaner and seafoam to start with. GET RID OF ENGINE CARBON! Believe it or not, spraying a small stream of water through the brake booster vacuum line of your engine can clear away carbon deposites VERY efficiently. (Just don't hydrolock your engine, if the engine is choking too much push on the butterfly valve on your TB)

For any vane-flap Toyota vehicle. 22RE's, 3S's, VZ blocks... And most other AFM vehicles.

This is a vane-flap air-flow meter. You slice the silicon glue off the top, and pry the black plastic top off Exposing the innards.



An AFM. It is not a MAF... They measure the VOLUME of airflow, by a flap, held closed by spring tension. On top of the flap is a small arm, which rotates along what essentially is a pointometer.

The ECU sends an exact voltage to the AFM, and reads the flap. It also reads a small air temperature sensor in the AFM housing. From this -> an AFM can accurately meter the MASS of airflow. (the important part!)

1) Reset the ecu - pull the EFI fuse for one nanosecond and replace it
2) Cut glue
3) Pry UP plastic top
4) PAINT THE STARTING COG
5) Rotate cog clockwise

3 clicks, 5 clicks, 7 clicks seem to be where people like. As soon as you get over the shock factor, most of the gain is 5-7 clicks.



You'll gain mid rpm range power. You'll also gain top rpm range power under a high load (i.e. top gear-top speed runs). Don't be surprised if you rev back to back in park and it's a tad slower from less fuel -> it will be noticeably faster on the street when there is a load on the engine.
__________________
Forum Guidelines:http://www.automotiveforums.com/vbulletin/guidelines.html

"What we've got here is a failure to communicate"

Last edited by Brian R.; 08-13-2005 at 12:56 AM.
Brian R. is offline