please help myself on this project, I recently did the programing for my 1995 Buick LeSabre, just not sure if the same complies with this vehicle.

1) Jump pins 4 and 8

2) Turn key to ON position

3) Hold lock/unlock buttons on the remote fob.

4) When doors cycle through lock and unlock, the fob is ready.

Please let me know if this is the correct set of steps, Thank you...

Our Buick Tips & Maintenance forum has the RKE programming for the '98 PA. See link below.

Click here (http://www.automotiveforums.com/vbulletin/showthread.php?t=118683)


1 Turn OFF the ignition switch.
2 Use a fused jumper wire in order to connect the data link connector terminal 8 (BLK/WHT) to terminal 4 (BLK).
3 Close all of the doors.
4 Turn ON the ignition switch. The door will cycle to lock.
5 Press and hold the following buttons on one of the transmitters for 30 second:
LOCK
UNLOCK
After a 30 second delay, the doors will lock and unlock.

Important
Do not turn OFF the ignition. If the switch is turned OFF, the first transmitter becomes inoperative.


In order to program extra transmitters, repeat Step 5.
Disconnect the fused jumper wire from the data link connector (DLC).

Thank you for such a quick response, I hope to be as informant..

My Brother has a 1998 Buick Park Avenue Ultra, is the steps the same?

My Brother has a 1998 Buick Park Avenue Ultra, is the steps the same?

Same procedure.

Thank You Again...

Also my brother included that his car has the heads up display with DIC