Register and join the largest automotive community online!
Please Register or Login to access: DriverSide DriverSide Home | Service & Repair | Car Prices | Parts & Accessories | Reviews & Advice | My Garage

92chevy lumina stalls


Google  
Web AF

chefmaq
01-06-2009, 04:45 PM
:banghead: i have a 92 chevy lumina 3.1 v6 auto trans. 199,306mi. the car starts and runs rough it will let me drive about 1 mile and then it starts to stall at every stop sometimes if i ride the brake and gas i can keep it runnig.but it still sputters chokes and backfires. i have replaced the egr valve map sensor ,engine coolent temp sensor vacum harness and hoses. i just tried a new iac valve and it still did the same.kno i am begging for the right solution.please

ty mike

MagicRat
01-06-2009, 06:51 PM
You have actually posted in the Chevette forum. For a moment, I got all excited because I thought someone out there actually still drives one :smile:

Your trouble could be explained by bad plug wires.

When the insulation breaks down on the spark plug wires, the spark energy can jump to ground or jump to an adjacent plug wire, causing weak, erratic and improperly-timed sparks.

Also, a worn timing chain, or one that has jumped a tooth can also cause this trouble.

mgty3whlr
01-07-2009, 08:43 PM
:banghead: i have a 92 chevy lumina 3.1 v6 auto trans. 199,306mi. the car starts and runs rough it will let me drive about 1 mile and then it starts to stall at every stop sometimes if i ride the brake and gas i can keep it runnig.but it still sputters chokes and backfires. i have replaced the egr valve map sensor ,engine coolent temp sensor vacum harness and hoses. i just tried a new iac valve and it still did the same.kno i am begging for the right solution.please

ty mike

Bad fuel injector(s) they were common! Big time
A high resistance in the injector will cause the rough running and stalling.
being that 3 of the injectors run from one driver and the other 3 run from the other driver.
what happens is the high resistance in one or more injectors will feed back to the computer and cause the other injectors not to fire properly causing this condition.

The unfortunate thing is that you have to remove the upper intake plenumn to access the injector to measure the resistance.

remove all of the injector connectors and measure the resistance of each injector.
anything under 12 ohms, the injector is bad.

Add your comment to this topic!


Google  
Web AF