1994 corsica


esrman
10-30-2008, 04:34 PM
I had the sound like the cv joint was bad so replaced it,sound still there.

Took to Sears and they said it was the strut,replaced that ,also had new wheel bearing put in,and sound still there!.

I think its the a-frame bushings,what does anyone else think?

Thers actually 3 sounds.

When I stop at about 25 mph or faseter,it sounds like the brake pads are rubbing,but they`re good.So is rotor.

Alos if I hit a little bump it sounds like its bottoming out.

Schrade
10-31-2008, 11:43 AM
I had the sound like the cv joint was bad so replaced it,sound still there.

Took to Sears and they said it was the strut,replaced that ,also had new wheel bearing put in,and sound still there!.

I think its the a-frame bushings,what does anyone else think?

Thers actually 3 sounds.

When I stop at about 25 mph or faseter,it sounds like the brake pads are rubbing,but they`re good.So is rotor.

Alos if I hit a little bump it sounds like its bottoming out.

Well for starters, get your cash back from Sears. Hope that doesn't take too long for ya'...

The sound you get when going over a bump might be a missing bushing in the suspension somewhere...

slick55
11-07-2008, 08:39 PM
how do I change transmission shif cable on 99 corsica

slick55
11-07-2008, 08:44 PM
Well for starters, get your cash back from Sears. Hope that doesn't take too long for ya'...

The sound you get when going over a bump might be a missing bushing in the suspension somewhere...

you might want to check your ball, joints, and a frame bushing so times they will make sounds like that

esrman
11-08-2008, 02:28 AM
Hers what`s been done so far.

Replaced:
1.Ball Joint.
2.Strut and Bearing Plate.
3.CVC Joint
4.Wheel Bearing.
5.Control Arm Bushings.

What`s left to replace?

Add your comment to this topic!