Page updated on 05-26-2018

d16z6 cam

01-27-2008, 11:19 AM
I am looking for a good cam for my d16z6. It is na and has i/h/e if you had any questions about my setup. Is the 59300 good for non turbos? Also would I have to replace anything else? Sorry new to the engine building and just want to do it right. Thanks.

01-28-2008, 09:12 AM
depending on the cam... its recommended you get Ti retainers, and the more aggressive the cam, it will require Ti retainers, dual valve springs and maybe even forged valves

01-28-2008, 09:26 AM
i was looking at the skunk2 stage one cam it says that it would be ok to use stock parts would i be ok then

01-28-2008, 12:34 PM
you would be alright... but you may see parts wearing out faster than normal

01-28-2008, 01:23 PM
thanks i have been looking for advice every where and this is the first response i have gotten is that a good cam for my car will and is it a noticeably differnce.

Add your comment to this topic!