Anyone know where I can find a 2-pin tool to remove my hub (wheel bearings)?

I'm stuck...

Thanks,

Larry

If you're lucky, a non-chain auto parts store might have one. Look for one spec'd for 1998+ Isuzu trucks, 1989+ Honda Passports, and Jeep J20 w/ Dana 60 axles.
Or order one here:
http://www.ontool.com/store/product/1382-80

That one is known to work. I found one with the above spec at a local parts store but the pins were a little thicker than the Ontool one and I had to cut them down a tad with a Dremel to make them fit into the holes on the locknut. If the pins are nearly 1/4" wide, they won't fit, if they're closer to 1/8" wide, they will.

Good luck,
Brent