Our Community is 940,000 Strong. Join Us.


1994 Ford Crown Vic P71 For Sale CHEAP!!!!!!!


Techyon
03-21-2006, 01:00 PM
400.00 Or Best Offer!

MUST GO

412-335-8062



1994 Ford Crown Vitoria P71 Police Interceptor
VIN # 2FALP71W9RX169362
This vehicle has 155000 miles
5.0 (4.6) Liter engine,
All wheel disk brakes
Tires are 80%!
4 Wheel ABS
4 Wheel Disk Brakes

This car would be a easy project to complete, or use as a parts car.
The Engine is a Strong runner

About:
Ok, Here's what I know about this car, it was originally a Penn Hills police car,
this car was acquired from the auction by a older gentlman whom I know and was very
meticulus about his cars.
This car runs great, No noises or any problems. It had sat for 4 years too!
The previous owner was elderly and had to be placed in a home
The cosmetic condition of the car is approximatly a 6 out of 10.
The paints original clear cloat is blemished with scratches but cleans up ok.
Front seats are cloth, rear seat is vinyl.
Rubber floor mat.
Drivers door panel has one crack in the arm rest.
Roof has one 1 1/4" open hole from the lightbar cable."currently covered with duct tape".
The body is mostly straight, no major dents or blemishes!
It has had some type of bodywork done on the left rear quarterpanel by the deck lid.
Some rust has blistered through the spraypaint finish. Nothing major!
The Hood appears to be aluminum, and corrosion free.
The back Bumper cover has a small tear next to the license plate.

What's been replaced: He had replaced a lower ball joint on the right front wheel shortly after purchase and replaced
as well as the brake line to the left rear wheel.
He had also changed the transmission out right before he quit driving.
The speedometer does NOT work. Im pretty sure he replaced the tranny with a transmission from
a non Police car "its the same tranny though" but it didnt have the digital output.
I havent looked into that yet.
I've replaced the line to the right rear wheel as well now.
Problem point: The Proportioning vavle for the right rear wheel is stripped. Needs Replaced!
See the additional pictures.
The battery is almost new that I just put into this car, was used for 6 months in a truck I junked.

What this car needs
It needs the ABS Proportioning block for the right rear wheel, See Pictures!!!!
The transmission/speedometer cable figured out. I personally was going to take it to a shop
for this to save confusion.
Possibly a steering box, It felt loose to me when I drove it around alittle bit.
I drove it without brakes so it was interesting!
A new home, I have no time for this project and no place.. I have too many things going on currently.

Techyon
03-21-2006, 06:15 PM
http://clanmage.net/~techyon/Techs_Garage/94_crown_victoria/left_front.JPG




Rest of the images here:http://clanmage.net/~techyon/Techs_Garage/94_crown_victoria/

Techyon
03-23-2006, 05:32 PM
Hey Guys, Update.
If the car doesnt sell.. I am going to dismantle it for scrap
So at this point.. Any Offers considered.
I will only get 125.00 avg for the car as a whole for scrap
However I will be cannabalising it for anything aluminum to make my money

I have exactly 330.00 invested....
Make Me an Offer I CANNOT Refuse.

cobradude360
03-24-2006, 08:26 AM
where are you located?

Techyon
03-24-2006, 03:24 PM
My bad,

I am located just outside of Pittsburgh Pa in
Monroeville Pa
Zip code: 15146

reekor
03-25-2006, 12:17 AM
If you end up parting it out or scrapping it, I'm interected in the ECM (computer).


Hey Guys, Update.
If the car doesnt sell.. I am going to dismantle it for scrap
So at this point.. Any Offers considered.
I will only get 125.00 avg for the car as a whole for scrap
However I will be cannabalising it for anything aluminum to make my money

I have exactly 330.00 invested....
Make Me an Offer I CANNOT Refuse.

Techyon
03-25-2006, 09:58 PM
Make me an offer for the ECM then,

I'll sell it as parts from here on out.
I just came home from Reading Pa with a 84 Chevy S-10
and I could use the extra bucks for the suspension lift I purchased for it already.

Now Taking Requests for Parts!

Techyon
04-02-2006, 11:28 PM
Reekor,

Do you still want the ECM?
I'm stripping the car down now.
Sofar I've started tearing down the engine and the rearend of the car is stripped as well.

Parts Cheap Guys!

If nobody takes first dibs here it will be on ebay tommorow

gilprice
05-18-2006, 02:36 PM
Is the computer still available? If so I'll make you an offer via e-mail. You can send to me at gprice"at"gilprice.com , just change the "at" to the usual.

Thanks,

reekor
05-19-2006, 07:51 AM
The computer is in my car now.

Is the computer still available? If so I'll make you an offer via e-mail. You can send to me at gprice"at"gilprice.com , just change the "at" to the usual.

Thanks,

reekor
05-19-2006, 07:53 AM
By the time I seen your post you already had it on Ebay, The ECM works great and I have left feedback for you as well.

Thanks

Reekor,

Do you still want the ECM?
I'm stripping the car down now.
Sofar I've started tearing down the engine and the rearend of the car is stripped as well.

Parts Cheap Guys!

If nobody takes first dibs here it will be on ebay tommorow

Add your comment to this topic!