Hi all,

Got a 94 Lesabre, Wife went to work, went to leave, started car, and car dies.

It seems like it will start no prob and run while cranking when key goes to run position it dies. Sets no codes

Tech has replaced crank sensor, ICM, Pass Module, ECM. Still no luck.

Any Ideas, Suggestion, or solutions

All answers Appreciated

A faulty VATS module could cause the car to stall once the engine is running. The module sends a Pulse Width Modulated signal to the PCM. If this signal is not present, the PCM will not provide injector pulses thus causing the engine to stall. Have your injectors tested with a noid light while stalled, or not starting.

had same problem on 95 it was bcm tried used one still running $60.00

I had the same problem and it was the air filter hose had a small cut in it. This might work might not