If anyone is interested I've got the following used parts all cleaned up and sitting at a local garage... (hey, is there any other place in AF to post classifieds??)


http://www.fastengineparts.com/produ...701dfd0ba73ab2
Set of 8 over .030 SBC hypereutectic pistons made by Speed Pro (aka Sterling/Federal Mogul). No idea what compression is (the link says Flat-top with 4-valve relief, compression distance 1.550). For use in 1990-1997 small block.

http://www.gmpartsdirect.com/results.cfm
Set of 8 SBC 5.7" powdered metal connecting rods. GM Performance Parts uses these rods in many of their crate engines (they're factory LT1/LT4 rods which replaced the heavier & weaker shit used in older Gen I SBC's). Good to 500 horsepower.

http://www.nopicsyet.randy.com
LT1 cast iron crank. 3.48" stroke, 1 piece rear seal. As far as I know these cranks can only be used in other Gen II V8's (1993-1997).


I'd like to keep these parts as expensive paper weights or eye sores but if I can get a few bucks for them they're yours. PM or email me for more info - randegos@hotmail.com.

BTW in case its not obvious I'm in Toronto a little more than 1 hour north of Niagara Falls. I make regular trips down to St. Catherine's ONTARIO which is 20 minutes from the Queenston/Lewiston bridge, so for NY folk I could meet you at any boarder crossing.