Our Community is 940,000 Strong. Join Us.


replacing 4.3, need a suggestion


DWJONZ
01-29-2006, 06:40 PM
My 93 4.3 has 200,000 and a rod knocking, so got a new 4.3 to put in. Now I can't get the engine out because the oil pan hits the 4x4 front axle. I could fight the oil pan and get it off, but then how would I get the new engine in? It would be impossible to get the new gasket and pan back on.

Any suggestions?

bigd7315
01-29-2006, 07:40 PM
cut crossmember on each side of the oilpan with a sawzaw and have someone weld it back when done just did this a month ago on mine the fram won't move when crossmember is cut

herkyhawki
01-30-2006, 08:53 AM
You do not have to remove the oil pan to pull the motor out.
Did you disconnect the engine from the transmission?

OverBoardProject
01-30-2006, 09:37 AM
You also might have to remove the motormounts. But not the pan.

If it's standard it's harder than automatic. Since you have to slide the motor forward off the shaft. (or so I'm told)

I would never cut the crossmember. Even if it's stronger after you get it welded the police or safety inspectors might pull it off the road just for that.

Add your comment to this topic!