eccentric shaft

where the shit do i get a socket big enough to fit the damn eccentic shaft nut?

Try a local big rig repair shop and see if they will loan one out to you or if there is an autozone near you see if they have one large enough in the loan a tool service.

HAVE FUN

cause that shit is a bitch

welp my buddy has the socket i can use, and my buddies dad has a 3/4 in. impact gun so it aitn gonna be that hard

Lol

What Size Socket is it anyways? As I have a 1inch 3/4inch and 1/2inch gun.

Sad thing is the 1/2inch will out torque the 3/4, but the 1inch owns all. max 2400ft/lbs

Should be plenty no?

Even with the right socket its hard to get off there. There is actualy a special tool to do that. You can buy the plate that holds the flywheel while you attempt to remove the nut. :P

good luck

its 54mm. and ill be surprised if the impact gets it off

ok well if an impact wont get it off....then what will? caz i sure as hell aint gettin it off by hand, hand or air is my only options... so how do i get it off? lol and its 2 1/8 6point!

Like FDTT said there is a tool to take it off but you can lock the motor down and use a power handle with a cheater bar to break it loose.
Cheater bar= anything large enough to fit over a power handle and strong enough to turn it without bending.

ok and what is this tool? and where can/do i get it?

Price of the tool. http://mazdatrix.com/getprice.asp?partnum=49-220NT

Picture and other holding tools. http://mazdatrix.com/toolmisc.htm