Need instructions on how to replace MAP sensor...PLEASE!!!

I need to replace the MAP sensor on a 96 Honda Accord, 2.2L.

Can someone please give me as close to step-by-step instructions on how to do this. My sister-in-law is going to be bringing me the car and I'm not familiar with Hondas. Any help you can provide would be greatly appreciated...

Also, just to be sure, the computer code (P0108 Manifold Absolute Pressure) is what I'm going by. Is it pretty safe to say that when that code come out that it truly is the MAP? Or, could something else cause that code?
Just checking.

Any quick responses would be greatly appreciated. Thanks..

Well I did a search and found this:

http://www.automotiveforums.com/vbulletin/showthread.php?t=393923&highlight=P0108+Manifold+Absolute+Pressure

I don't have step by step instructions on replacing the MAP sensor in a Honda, but I would assume it to be rather straight forward if you know what you are looking for/at.

Also, how would I reset the CHECK ENGINE light after replacing the MAP?

Also, how would I reset the CHECK ENGINE light after replacing the MAP?

Usually all you have to do to reset the check engine light is to unplug the ecu for a few minutes, you can also disconnect the battery for a while.

a link that might help Vacuum Distribution (http://www.insightcentral.net/encyclopedia/enrvr.html) the ECU should reset itself after the car is shut down for a short time if you have the OEM radio donot disconect the batt unless you have the sterio coad !!