I was having a problem with the swith that pulled back to turn on the high beam because a plastic piece that held the rod cracked. I want to rewire the highbeams from the stock push button under the dash behind the steering columb to a new push button that i would like to mount in with the dimmer switch and headlight switch. The problem is there are four wires connected to the stock switch and i believe two are for the headlights since I unplugged the connector and only my corner lights lit up until i plugged the connector back in. The connector has 2 light green wires, 1 that is thicker than the other, a yellow wire, and a salmon wire. Which wires do I need just for the high beams? Any information is greatly appreciated.

If the 91 panel is like the earlier i might be able to help.

I can't switch my high beams on either using the stick on the column. What's this "under the dash" switch you're talking about though?

i dont know, but this is three years old.

this thread will be closed cause it is too old, just make a new one

this thread will be closed cause it is too old, just make a new one
You are correct sir!