Ok, not to give you a long background story, but I tore open my oil pan, broke a motor mount and bent my shift linkages playing chicken with an abnormally high man hole cover...I lost. So since I have to do some work to my car, I am going to install my turbo set up that has been sitting in my garage for about a year and a half, I'm a procrastinator. So I have a JDM B16A1, 255 walbro fuel pump thus far and I'm going to need some injectors, I am going to get some MSD injectors because I can get a hook up. So with that said, what size injectors will I need? I am aiming for 1 bar / 14-15 lbs of boost (Yes I'm rebuilding my bottom end with pro crower rods and pistons I haven't picked out yet). I'm also getting a Vector X intake manifold and my e-manage can control 2 sets of injectors. Should I go that route, 2 sets of injectors? If so what size injectors will i need for that? Should I post this question in the tech forum?

what I have/going to get
JDM B16A1
Vector X intake manifold
turbonetics t3/t04b
oversized f/m intercooler
msd 6a ing. system
GReddy e-manage full system, Injector & Ignition controls
255 walbro fuel pump
other stuff that really doesn't pertain to this question and too long to list.

djk1

Whats the cfm rating on your turbo?

Not sure, the turbo has been sent off to be rebuilt, but I haven't talked about the specifics yet. I'm aiming for about 300hp at the crank, I would love to have 300hp at the wheels, but I want to be practical and reliable. what do you suggest for this set up since I am having the turbo rebuilt I should be able to size the turbine to my specs.

I did a huge write up on this along time ago...ill see if I can dig it up.

Choosing the right size Injectors (http://www.automotiveforums.com/vbulletin/showthread.php?t=250614&highlight=injectors)

dont go 2 sets, just get bigger and go single set

too complicated, get dsm 450s, they are good for 300whp. and if the turbo is a good size then you dont need to go 14psi to reach 300whp.

Thanks, that was what I needed!

Witht the right tuning you can easily put down 350 on pump gas to the wheels w/14-15 psi. watch the injector duty cycle. I would go with rc 550 saturated to be safe.