How do I remove the panels in the back of my 2 Door 99 Blazer LS?
I think my back passanger side speaker may be loose and want to tighten it up. Im sure it is what is causing the bad rattling noise I am getting from the panels.
Also, does anyone have any other panel noise making fixes they would like to share?

I had to rattle proof my truck a while back!
I removed almost all the panels and added wheather strips under each pannel.
It worked perfectly!

That's great. So how did you remove the back panels? And what kind of stripping did you use?

Unfortunately I haven't seen the inside of a 99LS, But I'm sure someone in this forum could answer that for you.

I know with mine, a few of the panels covered screws holding others panels up.

I used something similar to this stuff.
http://jacksautoparts.com/catalog/weatherstrip/trunk.jpg
You can get it at any hardware store, cheap!
It works really well!

Just thought I would update and let anyone that cares know how I fixed the noise coming from the panels.
Removed the panels and then where the panels clip, took 3M double sided tape and ran it on the edge, used a knife to cut a slot for the clips to slide into as well. Put the panel back together and no more noise. The inside of the cab has never been this quiet since I bought my Blazer. Very impressed!

What did you use to pop the clips off on the panel? This is one of my projects too!

A soft cloth over a flat head screwdriver..just pushed in a bit and popped it up.