Is there anyway to take that god awful air flow reader of the intake pipe connected to the turbo and run it like that with out any problems ? or do u need a computer upgrade etc? please let me know is if there is anything ican do to get rid of it!!!!!!!

You mean the mass air flow meter? If so you can switch to speed density. But its not needed with only a few modifications. It is a high tech system.

What are your goals?

The AFM will not hold you back to making 300 RWHP.

As MR2turbo93 pointed out, you can switch to a speed density set up. The easiest way to do that is the HKS VPC (not available new any more). They sell used for $500-$700. The VPC is a fine option except that a lot of people expereince sporadic idling isses. I used the VPC for a good 2 years.

The best option would be to go to a full EMS (Engine management system). That is what I did this winter.

What are your goals?

The AFM will not hold you back to making 300 RWHP.

As MR2turbo93 pointed out, you can switch to a speed density set up. The easiest way to do that is the HKS VPC (not available new any more). They sell used for $500-$700. The VPC is a fine option except that a lot of people expereince sporadic idling isses. I used the VPC for a good 2 years.

The best option would be to go to a full EMS (Engine management system). That is what I did this winter.


Which EMS are you using? Do you have any website where I can go look it at?

JDMR2

I went with the Hydra Nemesis from mrcontrols:
www.mrcontrols.com
Talk to RickyB and tell him I sent you ;)