Our Community is 940,000 Strong. Join Us.


Apex Seal?


EVOclipse
02-16-2005, 11:21 AM
Ok im looking at going RWD , anbd i found a nice 86 RX-7 with no rust and good body interior, its got AC and everything, just over a 120k, for only 700$ maybe a little less(prolby) only thing the guy said he was having problems is that it needs an apex seal or something. on the first rotor, i dunno shit about the rotary's yet so any help here would be appreciated. thanks

D3rELiC
02-16-2005, 02:51 PM
it will need a rebuilt, wich is in the 500-2000$ range depending on what is fucked inside, and what work you wanna do

EVOclipse
02-16-2005, 03:38 PM
dunno like i said he said it was the apex seal ,but that the car runs fine he drove it about 20-30 miles to show it

D3rELiC
02-16-2005, 04:11 PM
dunno like i said he said it was the apex seal ,but that the car runs fine he drove it about 20-30 miles to show it

i was lying, dont beleive me.

drftk1d
02-16-2005, 04:34 PM
an apex seal is basically a more critical piston ring for the rotary engine.

EVOclipse
02-16-2005, 05:24 PM
so its like a non expensive part(relativly) but a bitch to replace. so expensive if i had it done? thats what im kinda getting at?

D3rELiC
02-16-2005, 05:39 PM
so its like a non expensive part(relativly) but a bitch to replace. so expensive if i had it done? thats what im kinda getting at?
lets say you do the work yourself

you'll have to take the engine out of the car
then open the engine, wich means a gasket and o-ring set to start off
$200
you'll have to buy the atkins cassette to know how to rebuilt your engine
$30
you'll also have to buy new apex seals
$200-250

you'll have to check if your seals are on spec, seals and groove
you also gotta hope the guy isnt raping the rotor housing while runing with a faulty seal, cuz that might kill the housing, wich cost $500 a piece, new
rotors can also be damaged by those kind of wears, wich is also $500 a piece.

a base rebuilt by someone knowing is stuff is no where below $1k
and in the $600 range to have the engine removed and installed

RevvRX-7
02-16-2005, 09:13 PM
Since were talking about seals..where are the coolant seals located on the engine? Is there a diagram that points all this stuff out?

D3rELiC
02-16-2005, 09:54 PM
coolan seals ? you mean, the one for the waterjackets ? its the o-rings all arround the housings

Add your comment to this topic!