They cost about $35.
Are they really this expensive?
This sensor goes to the bottom of the radiator with two wires.
I tested it and it is open, no resistance reading.
I heated it up with a gas lighter and no change.
What is the resistance reading at 35F, 60F and 180F? Any ideas?
Thanks for any reply.

11 views and no replies. C'mon guys, somebody knows about this.

Ok, I only have the Haynes manual and it has no mention about this temp sensor.
Maybe somebody has a Factory Service Manual and can look it up for me.
Is this just a switch, temp dependent resistor, or a thermocouple?
Thanks in advanced.

HMMMMMMM. I will take a look in alldata monday..

but if i had to guess the ecu uses this sensor for emossion control where as the sesor on the thermostat is only used for the gauge onthe dash.

I found a cheaper one at Advanced. $26

I tested it with my fluke meter.

Still confused. New one has neither resitance reading nor millivolt reading.
Not even a switch contact that makes when heated.
I will install it and see what happens.

I found a cheaper one at Advanced. $26

I tested it with my fluke meter.

Still confused. New one has neither resitance reading nor millivolt reading.
Not even a switch contact that makes when heated.
I will install it and see what happens.
hey i got like 8 mazda pickups partein out i will sell you waht vere you need email me for any parts i got every thing andi mean every lil thng i saved and for sale prices right email me at toplessmazda87@hotmail.com

Finally traced the temp sensor function that is located in the bottom of radiator.

It is not a temp sensor, it is just a cold temp switch.
The switch makes around 55F and opens around 60F.
Tested the switch by dipping in iced water and the switch closed using a digital meter.

This cold temp switch activates the PTC heater in the bottom of the carb to prevent the carb from icing up during cold weather start-ups.

Just for everybody's info.