Looking for the bracket that the hub bearing and the brake caliper mount to. Can I swap this out with one from a XJ with ABS or is this a GC specific item.

You're talking about the knuckle,right? Anything but a WJ should fit

You're talking about the knuckle,right? Anything but a WJ should fit


i think he means the the rotor shield thats the steel round plate the caliper and the hub assembly bolts to they should be interchangable
dale

Yes, I'm talking about the knuckle. Its the part that the caliper, tie-rods,ball jionts all bolt to. Oh and the Hub bearing too. So I can get one off of an XJ as long as its ABS?

well then a steering knuckle from any ZJ should fit, and one from an XJ should fit as well

the xj part will be fine.Doesn't matter about abs unless its the axle shaft.The tone ring is on the outer end of the axle.

Found a cheaper fix, found the M8x1.25 Hela coil kit at ADvance Auto, so tonight I will finish this project.