power seat not working


jimb317
10-19-2004, 05:55 PM
I have a 2000 GMC Jimmy. the drivers power seat is not working. the lumbar works fine. I have power at the switch. but I can't figure out what is wrong. Is there a relay for each motor? Is there an easy way to fix this?

bearcatdon
10-20-2004, 07:37 PM
I believe there is a 20A fuse in the vehicle and a 50A under the hood. Make sure you check both places.

ManofGMC
10-22-2004, 10:12 PM
I can't go in reverse. It worked fine earlier now Noway No how. When driving it runns rough and in the high rpms. Transmission? Please advise.

BlazerLT
10-23-2004, 04:02 PM
Grease the track and check for obstructions and jamming.

hamlinhazel
12-06-2004, 01:08 PM
I had the same problem with my 2000 LT Chevy blazer. It turned out to be under the back seat under the carpet. The wires were corroded.

BlazerLT
12-06-2004, 03:56 PM
under the back seat?

hamlinhazel
12-10-2004, 08:37 AM
Yes, it was under the back seat. The whole back seat had to come out! GM needs to come up with a better plan for all of these power cables! Running them on the floor is not a good idea!

BlazerLT
12-10-2004, 07:23 PM
How does wiring under the back seat have anything to do with the power seats in the front.

capricorn1252
09-20-2013, 04:31 PM
from other forums found that Orange wire from 6 pin connector under seat had power - traced good continuity and power to lumbar switch but no power at seat 8 position switch - for grins ran jumper from orange wire on lumbar switch to orange wire on 8 position seat switch and seat became fully functional - so spliced in jumper between both orange wires and wallah ! the electric seat that didnt work for years is now working again. :lol2:

jdl
09-20-2013, 04:49 PM
Just thought I'd post a diagram, 6-way power seat circuit. Click on the link. Everybody have a good day.

http://s13.postimg.org/jwc4f6v8n/jimmy_6_way_power_seat_circuit.jpg

Add your comment to this topic!