Help on jacking points for a 91 Camry

Quick question on jacking points. I am trying to jack-up the front end of a 91 v4 Camry. I can see the front cross member, but it is too far to reach with my floor jack. There is a center member connected to the bumber and to the front cross member. Can I use that one without demolishing my rust heap?
Hilton/Chilton is not very clear on jacking points for a conventional floor jack, so any help would be much appreciated.
:1zhelp:

You can try it gently. Place a 2x4 between the jack and the car cross-member to distribute the load. Make sure the emergency brake is on and the rear wheels are chocked. Stop if you see any bending of the cross-member.

A better way would be to use the designated jacking points behind the front wheels. One side at a time with jack-stands inserted after the jack has raised one corner of the car. Then move the jack to the other side of the car and repeat.

I'll try that, thank you very much.

You're welcome