p10 door speaker install

i couldnt actually do it but i saw it being done when an installer did it.

rear- lift the back seat up from the lip and remove it. very simple.
pull the back rest part of the seat up in the air because it is on hindges.
there are screws on the back of the seat that you have to unscrew from tthe trunk. lift up panel that lays over the speakers and unscrew. it makes it a whole lot easier if you have a power screw driver that can go at an angle.

front- take out screws around the door panel. pop out the window roll up button. remove big screw there and pull off. there are wires that are attached to the roll up button so be carefull you dont dammage it.

i dont nkow why infinity makes this process so hard!

It's easier if you also remove the door latch screw. It helps when prying over the latch. The front doors are a bitch but the rears are fairly easy. The biggest pain is finding a good quality speaker to fit the front. The door isn't deep enough for the larger magnet speakers. I ended up switching to Infinity Kappa 4x6 plates.