keyless remote
oldaurora
05-04-2004, 10:01 PM
I have a 98 aurora,one of my keyless entry units stopped working after a battery replacement.Can anyone tell me how to reprogram it. thanks. ps.is there a primary and secondary receiver,and how can i tell the difference if there is?
RoraStar96
05-05-2004, 10:25 AM
This was posted by MoshimoGTP in another thread...
----PROGRAMMING----
Perform the following steps:
Sit in the vehicle driver's seat.
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.
Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.
Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.
Remove the ignition key from the ignition lock cylinder.
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis.
Validate that all the transmitters that were programmed operate properly. Refer to Keyless Entry System Operation
----PROGRAMMING----
Perform the following steps:
Sit in the vehicle driver's seat.
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.
Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.
Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.
Remove the ignition key from the ignition lock cylinder.
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis.
Validate that all the transmitters that were programmed operate properly. Refer to Keyless Entry System Operation
oldaurora
05-05-2004, 03:45 PM
rorastar96,thanks for the input.i checked owners manual and my fuse block doesnt show a mall pgm fuse,there is a pcm fuse in slot number 10 that controls powertrain control module,vats pass-key II. Could this be it? thanks
RoraStar96
05-05-2004, 05:05 PM
That write up that I posted came from a GP GTP owner, so it may not be exactly the same, I just fired that off from memory.
VATS Pass key definitely is involved with your remote so its a good chance it may be it
VATS Pass key definitely is involved with your remote so its a good chance it may be it
dsatt12
05-10-2004, 12:43 AM
Look here. It was pretty well covered.
http://www.automotiveforums.com/vbulletin/showthread.php?t=153146&highlight=program+keyless
http://www.automotiveforums.com/vbulletin/showthread.php?t=153146&highlight=program+keyless
Automotive Network, Inc., Copyright ©2024