boost controller

bout to install a MBC on my 1g dsm, and ive seen a few diffrent ways people have done this on a 1g i was wonderin which way was best...
1)remove the boost control solenoid one hose to the wastegate acuator other to the BOV n block off the hole in the air can where the old hose was.
2}disoconnet the hoses from the BCS n tuck it away somewhere, the go straight to the acuator n plug off the air can hose n the hole where the hose went to the lower intercooler pipe, then to the BOV
3} and many variations of those above.

any suggestions on which is best! :uhoh:

dosen't vfaq show that?

www.plymouthlaser.com Book mark that. It will make life easier.

Michael