Molding my body kit/ "95 teg???

Hey i got a quick question... when i get my body kit put on my car i was going to sand and prime the car to be totally repainted afterwards. I was thinking of molding the kit to the body to make it more sleek, is this a good idea and if so what would be the best way to go about taking care of this.

Thanks much for any replies.

molding the kit will look very clean and good but i don't know how to do it.

If it is a daily driver don't do it, if it is a trailer queen/ show car then by all means do it. The body filler will crack as soon as you hit a pot hole, go to fast over a speedbump or take a corner too fast. My best advice is not to do it. Yes it looks nice but it is not worth it in the long run. :2cents:

:iagree:

I currently have molded rear bumper and molded side skirts. I havent had a problem for the past 3 years. I did not mold the front end due to above reasons, Never know when your gonna smack a parking curb. Go for the sleak look except not the front end.

like the above people said, the front you should definately not do. I would do the rear and sides, but I've seen those crack too.