Our Community is 940,000 Strong. Join Us.


Program 2004 Pontiac Grand Prix Remote


bobfo1
03-14-2004, 04:29 PM
Is the process for programming a 2004 Grand Prix Keyless Entry remote the same as older models?

Bill DCat
04-19-2004, 03:09 PM
I'm also interested in how to program a remote key fob to work with a 2004 Grand Prix. Thanks in advance.

mike1977
05-07-2004, 09:57 PM
Transmitter Programming
No Tools Required
In the event that a transmitter is lost, program the old and the new transmitters into the memory of the remote control door lock receiver. Up to 4 transmitters may be programmed.


Important
Once the keyless entry receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter programming information. You must then program all of the transmitters.

Program only 1 vehicle remote control door lock receiver at a time. If you program multiple receivers simultaneously, the same transmitter could possibly be programmed to more than 1 remote control door lock receiver.


Perform the following steps:

Sit in the vehicle driver's seat.
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.

Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.


Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.
Remove the ignition key from the ignition lock cylinder.
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis.
Validate that all the transmitters that were programmed operate properly. Refer to Keyless Entry System Operation .

© Copyright General Motors Corporation. All Rights Reserved.


--------------------------------------------------------------------------------
Document ID # 606238
2000 Pontiac Grand Prix

lakerfan1784
05-08-2004, 12:28 PM
that procedure does not work with the new grand prixs. it has to be done at the dealer with a scan tool.

Avalancher
05-08-2004, 02:34 PM
Actually from what I am seeing in my research of it, 2000 and up may need to go to the dealer.

lotsatreez
11-30-2004, 07:07 PM
so the above mentioned instructions wont work for my 04 grand prix?? (WONDERFUL NEWS) Does anyone know the dealer cost for something like this????

sincere58
12-07-2004, 04:06 PM
It costs around 35 bucks for the dealer to install

aarons04grandprix
12-12-2004, 02:37 PM
Do I really have to go to a dealer to get my remote programmed for my 2004 grand prix???

sincere58
12-12-2004, 11:08 PM
Sorry to say I believe it is the only way, unless somebody knows otherwise

Add your comment to this topic!