yo i bought these reverse glow gauges from www.alfaotto.com who manufacture the gauges as well... but i bought them assuming that they come w/ install instructions, BUT THEY DIDN'T! my car is a 93 mazda mx6 5-spd 4 cylinder. So now i have gauges sitting in a box in my car, and i need help! If anyone has instructions on how to install these gauges, or a website that has install instructions, or ANY helpful installation advice at all, please reply! Thanks for your help!

-Chad
93 Mazda Mx6 5 spd

pull up ebrake all the way, that panel under ebrake (the one the shifter pokes through) pops off, there are 3 screws above gauges, then the whole dash piece comes off, although there is a cable running from the center vent for the fresh air control, it is held on by one screw which is trickey to get on and off so be careful, then the gauge cluster comes off with like 4 screws (just look around the cluster before you pry it off) and unhook the harnesses off the back once the screws are off, then once you get the cluster off ... there should be some more screws around the outside of the cluster (be careful of the back side for the copper...ps this is a good time to change bulbs if you need to, also clean the lense before you put it back on, and make sure you have connected all the harnesses before you put the dash back together...

yah