i just got a performancec chip to put into my ecu. the chip i got has 14 pair of wire legs and i got another one with it that is just like it but its just the legs and a frame that you can plug the other one into. my ecu has chips the same dimentions as the ones i got but they all have 22 legs. wtf???

ok. in the bottom right hand corner of the ecu (wire harnes on the left side) there is a blank spot where the chip will fit but there is not an installed chip in its place. it is numbered 27256. would i then just unsodder the closed holes and plug the chip in there?

ok. i got detailed instructions from a guy off ebay. the chip goes in the empty slot and you have to take out another one, then add a jumber and a resistor in another place. thanks for looking. if anybody needs the instructions in the future hit me up.

You said thanks and nobody from here helped you. So your welcome

Originally posted by sindogg
You said thanks and nobody from here helped you. So your welcome

and the point of that post was what sindogg???