What Should My 1/4 mile Be?

Hey I have a 2000 trans am WS6 and i was wondering if anybody that knew what they were talking about could tell me what my 1/4 mile time should be with the mods that ive done.

Dyno Proven 400 Rear Wheel HorsePower
- Absolute Speed Custom Heads/Cam Package
- SLP Long Tube Headers / Y-pipe / Offroad Pipes
- SLP Air Lid / K&N Filter
- Corsa Premium Exhaust System
- Custom Dual Q-tec Cutout
(Open Headers at the flip of a switch)
- Red MSD Spark Plug Wires
- Cartek clutch with new disc, pressure plate, adjustable master and slave
- LS6 Intake Manifold
- Pro 5.0 Shifter with Lou's Short Stick Handle
- Hypertech Programmer
- Eradispeed Rotors
- Hawk Performance brake pads

given that you are probably somwhere in the high 11's low 12's range hard to say without goin to the track...

Mid 11's , definitly , with a good 60ft time anyway !

i got a question about your exhaust cutouts

how much did the cost and where did you get them from?

a et is really tough to say, it depends on your shifting, but i would go wit a mid- high 11

Traction Traction Traction. You can never accuratly guess on a 1/4 mile time. The 4th gens with 6 sps are very tough to leave hard without spinning. The ones I see usually have a slow 60ft time but have high mph . I will guess 12.8 at 110

my buddy has a z that puts down 405 to the ground and he ran a 13.2 at 105. your limiting factor will be traction

if you can get that power to the ground. you should do LOW 12s or mid 11s. if you can drive it. and of course get that power to the ground.