|
|
97 3.3 dies while driving - hard to startcj99 12-31-2003, 03:49 PM Died on my wife. She said it died while they were driving down the road abot 40mph. Started right back up again. I also noticed it has been harder to start lately. Turns over quite a while then almost doesn't start. Any suggestions? gforster 01-01-2004, 12:33 PM I would first suspect the Idle Speed Motor. About the only real way to check it out is with a scantool (shop) Also I would look at fuel pressure/pump/filter. Maybe go as far as to hook up a fuel pressure gauge to the fuel rail and monitor it when the engine does this dying thing... Are there any codes stored? MegaMax 01-01-2004, 11:34 PM It may also be the Cam Position Sensor (sp) That too will cause it to stall when driven... cj99 01-02-2004, 01:41 AM Had the fuel pump and filter changed recently. I think the ISM was changed a few years ago. I too suspect cam position sensor because it almost acts like a timing problem. Because of work schedule I have it at the dealership now being diagnosed. I will post the results. MegaMax 01-02-2004, 09:35 AM The part is about $50.00 and it will take 1 socket and under 5 minutes to change it out. Let me know what the dealer asks you for it if that is in fact the issue. Only reason I know this, my van did the same thing and my uncle did the diag on it for free and I changed the part. cj99 01-02-2004, 11:25 AM The part is about $50.00 and it will take 1 socket and under 5 minutes to change it out. I just spoke with the dealership. Naturally after putting it on their computer they could find nothing wrong and they would not listen to my suggestion of the sensor so I guess I will change it out myself if its not to difficult. I priced them already - about $35. I havent looked for it. Where is it located and how do I get to it? I wont effect the PCM by changing this will I? vBulletin®, Copyright ©2009, Jelsoft Enterprises Ltd.
Automotive Network, Inc., Copyright ©2009
|