where are the camshaft position sensor and crankshaft position sensor located? try to be describive. Thank you

The cam sensor is right under the P/S pump. The connector is to the right of the oil fill clipped to the bracket that mounts on the intake plenum bolt.

IIRC the Crank sensor is behind the Harmonic Balancer. Connector comes out below the water pump/ above compressor.

I couldn't remember if there where two crank sensors or not. Isn't there a low res one in the block on the firewall side as well? I think that's the one the the connector at the ignition module with the purple yellow wires go to. The [one behind the pulley is the high res and goes to the PCM. Again I'm going on foggy memory today. I should now that but it just isn't clicking! :)

The Crank sensor is a 7X, the Cam is a 24X or sumtin like that IIRC. I know there is a sensor between the narrow part of the transaxle and the side of the block, IDK what it is IIRC it is 2 wire and doubt it would be a position sensor as they are usually 3 wire.

I thought the one behind the crank pulley was the 24x crank sensor. The 2 wire in the block that goes to the ignition module is the 7x crank sensor.

Crank sensor is the 2 wire unit, the other 2 according to the wiring diagram are the cam sensors, IDK which is the 24x, I would suspect the one under the PS pump. - All info from www.autozone.com (http://www.autozone.com)....... :-)